AEG BSE576321M Manual De Instrucciones página 24

Step 9
If the door is installed correctly, you will hear a click when closing the latches.
The screen-printing zone must face the inner side of
the door. Make sure that after the installation the sur‐
face of the glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim clicks.
Make sure that you install the internal glass panel in
the seats correctly.
12.5 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
In any cases not included in this table please
contact with an Authorised Service Centre.
Problem
The oven does not heat
up.
24 ENGLISH
After cleaning, install the glass panel and the oven door.
Before you replace the lamp:
Disconnect the oven from the
Check if...
The fuse is blown.
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the
lamp.
Step 2
Put a cloth on the bottom of the cav‐
mains.
Problem
The Food Sensor does
not operate.
The door gasket is dam‐
aged.
The display shows
"12.00".
There is water in the oven
cavity.
A
Step 3
ity.
Check if...
The plug of the Food
Sensor is fully inserted in‐
to the socket.
Do not use the oven.
Contact an Authorised
Service Centre.
There was a power cut.
Set the time of day.
There is not too much
water in the tank.