Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTMENTS
WARNING
WARNING
CAUTION
Squaring The Saw Table to The
Blade (Fig. 8 & 9)
a. Turn the blade guide locking knob
counterclockwise to unlock the blade guide
assembly. Raise the blade guide assembly
as far as it will go by turning the blade guide
adjustment knob counterclockwise. Turn the
locking knob clockwise to the blade guide
assembly in place.
b. Place a small combination square (not
included) on the saw table beside the blade.
c. Loosen the two table locking knobs and
rotate the angle adjustment knob to tilt the
saw table up or down to align table 90°
to blade (0° position). Retighten the table
locking knobs.
d. Loosen the jam nut using the included flat
wrench.
e. Turn the adjusting bolt until the bolt just
touches the saw housing.
f. Check squareness of the saw table to the
blade. Make readjustments if necessary.
g. Once squareness is confirmed, retighten the
jam nut.
h. Using the supplied combination tool, loosen
the scale indicator screw, set the scale
indicator to "0" (zero), then tighten the screw.
NOTE: Always make a test cut to ensure the
squareness of the blade prior to beginning any
operation. If not square, it may be necessary to
loosen the four bolts under the saw table to make the adjustment (miter slot must be parallel
to the saw blade). Once square, retighten bolts.
16
To prevent personal injury, always disconnect the plug from the
power source when making adjustments.
To avoid personal injury, maintain proper adjustment of blade ten-
sion, blade tracking, blade guides, and thrust bearings.
Saw blades are sharp. Always wear ANSI Z87.1-approved eye protec-
tion, as well as protective gloves, while handling saw blades.
Fig. 8
Blade Guide
Adjustment
Knob
Fig. 9
Small
combination
square
Table
Locking
Knobs
Blade Guide
Locking
Knob
Blade Guide
Assembly
Saw Housing
Jam Nut
Adjusting
Bolt
Scale Indicator
Scale Indicator
Screw
Publicidad
