Battery fully charged.
Weak battery: prepare to replace the battery.
Dead battery: your 350 REMOTE TRAINER functions in safety
mode and the system locks up. The battery must be replaced.
Replace the old battery with a new one as follows:
▪
On the back of the remote control, unscrew the screw and remove the
battery cover.
▪
Remove the old battery.
▪
Insert the new battery (3-V lithium CR 2430) making sure the polarity
"+" noted on the battery is visible (ref. Diagram 6).
▪
Put the battery cover back in place.
▪
Retighten the screw.
▪
Check the remote control operates correctly.
Checking/Replacing battery of receiver collar
To check the condition of the battery, observe the indicator light located on the front of the receiver collar:
▪
Battery fully charged: flashes slowly green.
▪
Weak battery: flashes quickly red.
Replace the old battery with a new one (3-V Lithium CR2) (See § First use from new – Fitting the battery in the receiver collar).
Check the receiver collar operates correctly.
● Changing the contact points
Two different series of contact points are supplied. The length of the contact points must be sufficient to have proper contact with the dog's
skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate, remove and replace them with the
long ones supplied with the kit. Carefully tighten them manually (do not use a key).
● How to check that your product is functioning properly
You can check that your product is operating correctly at any time.
▪
Before doing so, make sure that the receiver collar is turned "off" (indicator light off).
▪
Place the neon test lamp in contact with each of the contact points (by unscrewing them then by screwing them up in order to grip wires
of the test lamp under the contact points).
▪
Turn "On" the remote control and receiver collar.
▪
Press the F or C button and modify the level of intensity of the static corrections: the test lamp must light with more or less intensity.
● Getting the best results
The training instructions you send to your dog are sent from the remote control to the receiver collar by radio waves.
These radio waves are sensitive and the range reaches approximately 350 yards (depending on geography and environment).
The performances of your product will be optimal if you respect the following recommendations:
▪
To obtain a good radio range, do not cover the part located above the LCD screen when you hold the remote control in your hand
▪
The position of the receiver collar around the neck of the dog should be in the following way: the On/Off indicator light is visible and is
not in contact with the breast of the dog
▪
Check the batteries (remote control and receiver collar) before using the unit and replace them as soon as the level of load is weak.
▪
The performances of the batteries decrease slightly under temperatures lower than 32Ft. If possible keep the remote control warm (e.g.
inside a pocket) before using it.
● Fitting the collar
The strap must be adjusted so that the contact points are in contact with the skin of the dog.
Collar adjustment is very important:
If the strap is too loose, the collar is likely to move and repeated friction can irritate the skin of your dog. Furthermore, it will not
function correctly.
.
- 4 -
Diagram 6
"+" of the battery must be
visible
.