Publicidad
Step 16
With a hammer, gently tap four SHELF SNAPS (8R) into the holes
å
in the ADJUSTABLE SHELF (I).
Insert the METAL PINS (1R) into the hole locations of your choice
å
in the LEFT END (A) and UPRIGHT (C). Set the ADJUSTABLE
SHELF (I) onto the METAL PINS so the SHELF SNAPS are resting
on the METAL PINS. Push on the SHELF until each METAL PIN
"snaps" into the SHELF SNAP.
To insert the drawers into your unit, tip the front of the drawer
å
down and drop the glides on the drawer behind the glides on the
unit. Lift the front of the drawer up and slide it into the unit.
Apply the WARNING LABEL (5L) to the upper DRAWER
å
BOTTOM (D733). You should be able to read the label when the
drawer is open. When the drawer is closed, it will hide the label.
Peel off the backing and apply the label as shown in the diagram.
Hang the ROD (17A) on the ROD HANGERS.
å
25 lbs.
17A
www.sauder.com/services
D733
I
A
40 lbs.
25 lbs.
25 lbs.
C
5L
40 lbs.
20 lbs.
25 lbs.
417146
8R
I
WARNING
Serious or fatal crushing injuries can
occur from furniture tip-over. To help
prevent tip-over:
-Place heaviest items in the lowest drawers.
-Unless specifi cally designed to accommodate,
do not set TVs or other heavy objects on top of
this product.
-Never allow children to climb or hang on
drawers, doors, or shelves.
-Never open more than one drawer at a time.
-If equipped with a drawer interlock system, do not
defeat or remove it.
Use of tip-over restraints may only reduce,
but not eliminate, the risk of tip-over.
Place the glide on the SLIDE
behind the glide on the RAIL.
6R
Page 21
Publicidad
