Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTING THE 3-POSITION WORKPIECE
GUIDE (FIG. 5)
1. Remove the battery pack.
2. Press the guide adjustment button and slide
the workpiece guide to the desired position
detent.
LED LIGHT
The LED light provides additional light on the
surface of the workpiece for operation in lower-light
areas.
The LED light will automatically turn on with a
slight squeeze on the variable-speed trigger switch
before the tool starts running and will turn off
approximately 10 seconds after the variable-speed
trigger switch is released.
The LED light will rapidly flash when the tool and/
or battery pack becomes overloaded or too hot,
and the internal sensors will turn the tool off if the
tool and/or battery pack are overloaded. Rest the
tool for a while or place the tool and battery pack
separately under air flow to cool them.
The LED light will flash more slowly to indicate that
the battery is at low-battery capacity.
Recharge the battery pack.
Fig. 5
Guide Adjustment
Button
Workpiece
guide
Fig. 6
-14-
B
LED Light
A
Publicidad
