Publicidad
Idiomas disponibles
Idiomas disponibles
SPEED DIAL (FIG. 9)
The band saw has a speed dial located on the
side of the handle to set the maximum speed.
Rotate the speed dial to "5" for maximum speed
or to "1" for minimum speed.
WARNING
speed changes while the tool is running.
VARIABLE-SPEED TRIGGER SWITCH
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON" or
"OFF" by depressing or releasing the trigger.
The variable-speed trigger switch delivers higher
speed with increased trigger pressure and lower
speed with decreased trigger pressure (Fig. 9)
PROPER HAND POSITION (FIG. 10)
To reduce the risk of serious personal injury,
ALWAYS use proper hand position.
Proper hand position requires one hand on the
main handle and one hand on the front handle.
GENERAL CUTTING
1. Remove the battery pack from the tool.
2. Make sure that the workpiece is firmly
clamped in place to keep it from slipping or
moving while cutting.
3. Install the appropriate type and size of blade
for the workpiece material and size.
4. Mark the line of cut clearly on workpiece, if
needed.
5. Attach the battery pack to the band saw.
6. Hold the saw firmly with both hands. Make
sure to keep your hands on the insulated
gripping areas only.
7. Bring the workpiece guide into contact with
the workpiece while keeping the blade off of
the workpiece.
8. Depress the lock-off button to the UNLOCKED
position and squeeze the variable-speed
trigger switch to start the saw and bring it to
the maximum desired cutting speed before
applying the blade to the workpiece.
9. Slowly and gently tilt the tool to bring the band
saw blade into contact with the workpiece.
Use only enough steady pressure on the
To prevent the blade teeth
damage, do not make any
Fig. 9
Speed Dial
Lock-off Button
Variable-speed Trigger Switch
Fig. 10
blade to keep the saw cutting. Do not force
the tool.
NOTICE: During cutting, if the band saw
becomes locked or jammed in the workpiece
material, release the switch immediately to avoid
damage to the band saw blade and motor.
WARNING
injury when they drop, after cut-off, should
be supported. End pieces may be hot
and sharp. Safety shoes and heavy gloves are
strongly recommended.
To prevent the blade teeth damage, do not
make any speed adjustment using the speed
dial while the tool is running.
-17-
End pieces, which would
be heavy enough to cause
Publicidad
