Publicidad
B9
B8
D
C
B
pop out the first wiring access slug. Use second if needed.
Insert the strain relief into the housing and
secure with the washer.
B11
B10
D
Move the housing into position above the ceiling.
pull the wires through the strain relief and tighten the
strain relief screws.
B12
B13
D
attach existing ducting to duct connector. Tape joints.
Fit housing into the opening and secure by tightening the
If ducting does not fit securely,
pre-loaded screws into the joist.
an adapter may need to be purchased.
Note: Install the box flush with the sheetrock (ceiling).
10
41717-01 02/16/2008
41717-EngS_2-16-08_Arial.indd 10
2/16/08 3:51:34 PM
Publicidad
