Epson TM-C3400-LT Manual Del Usuario página 157

10. Restricted Use
The Microsoft software was designed for systems that do not require fail-safe
performance. You may not use the Microsoft software in any device or system
in which a malfunction of the software would result in foreseeable risk of injury
or death to any person. This includes operation of nuclear facilities, aircraft
navigation or communication systems and air traffic control.
11. No Warranties for the Software
The software is provided "as is". You bear all risks of using it. Microsoft gives
no express warranties, guarantees or conditions. Any warranties you receive
regarding the device or the software do not originate from, and are not binding
on, Microsoft or its affiliates. When allowed by your local laws, SEIKO EPSON
CORPORATION and Microsoft exclude implied warranties of merchantability,
fitness for a particular purpose and non-infringement.
12. Liability Limitations
You can recover from Microsoft and its affiliates only direct damages up to
$250.00. You cannot recover any other damages, including consequential, lost
profits, special, indirect or incidental damages.
This limitation applies to:
• Anything related to the software, services, content (including code) on third
party internet sites, or third party programs, and
• Claims for breach of contract, breach of warranty, guarantee or condition,
strict liability, negligence, or other tort to the extent permitted by applicable
law.
It also applies even if Microsoft should have been aware of the possibility of the
damages. The above limitation may not apply to you because your country
may not allow the exclusion or limitation of incidental, consequential or other
damages.
13. Export Restrictions
The software is subject to United States export laws and regulations. You must
comply with all domestic and international export laws and regulations that
apply to the software. These laws include restrictions on destinations, end
users and end use. For additional information, see www.microsoft.com/
exporting.