Teac VRDS-701 Manual Del Usuario página 21

Using the number buttons to select a
track for playback
When playing or stopped, press number buttons to select a track by
number and start playback from that track.
To play a track with a single-digit number, press that number but-
ton. To play a double-digit track number, press the +10 button as
many times as necessary, and then press the corresponding number
button for the second digit. Playback starts after the track number is
input.
Operation examples
Track 7:
Track 23:
Program playback
Program playback is only possible with audio CDs.
Using program playback
1
Press the PLAY MODE button repeatedly until
PGM appears at the top right of the display.
TRACK 8
9
o If PGM is selected during playback, the playing track will be
added as program step 1.
NOTE
Programming is possible even when the tray is open. In this
case, track numbers 1 – 99 can be programmed. After a CD is
loaded, however, track numbers that are not on the CD will be
removed.
2
Use the number buttons to input track numbers.
See "Using the number buttons to select a track for playback"
for instructions about inputting tracking numbers.
Display example
Track number
TRACK 8
5
P01
Continued on the next page
e
PGM
25:48
5
P01
Program step
PGM
4:04
21
EN