STAMOS S-PLASMA50U Manual De Instrucciones página 16

NOTE! Although the equipment has been designed to be safe and has been provided with adequate safeguards,
and despite the use of additional safety measures, there is still a low, residual risk of accident or injury during its
operation. Caution and common sense are advised when using the product.
2. TECHNICAL DATA
Product name
Model
Rated supply voltage [V~] / Frequency
[Hz]
Cutting current
Idle voltage [V]
Rated duty cycle
Cutting current at 100% operation cycle
Ingress protection
Arc ignition
Supply air pressure [bar]
Compliance with standards
Work cycle
Measured input power
Measured output power
Calculated efficiency %
Minimum calculated performance
Ambient temperature
Input voltage
Frequency
Test time
Measured input data at the beginning
Measured input data at the end
Work cycle
Measured input power
Measured output power
Calculated efficiency %
Minimum calculated performance
Ambient temperature
Input voltage
Frequency
Test time
Measured input data at the beginning
Measured input data at the end
3. OPERATION
3.1. GENERAL NOTES
• Use the equipment as intended, in accordance with OHS regulations and restrictions resulting from data on the
nameplate (IP code, power supply voltage, etc.).
• The manufacturer shall not be liable for technical changes of the equipment or material damage resulting from the
introduction of these changes.
S-PLASMA50U
230/50
25-50A
300
30%
27A
IP21S
HF
3,5-5,5
EN60974-1
S-PLASMA50U
30%
5 834
5 064
86
Power measurement at rest
S-PLASMA60 U
30%
7 764
6 850
87
Power measurement at rest
Plasma Cutter
S-PLASMA 60U
400/500
25-65
310
30%
36A
IP21S
4-6
EN60974-1
60%
3 682
3 258
87
86
20°C
230V
50Hz
10 min
16.99W
15.28W
60%
5 108
4 540
88
87
20°C
230V
50Hz
10 min
18.85W
17.57W
HF
100%
2 848
2 550
88
100%
3 812
3 376
88