Examples Of Controlling Entrances; Installation A Controlled Entrance Or Exit - BFT PERSEO-CBE Instrucciones De Uso Y De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

13. EXAMPLES OF CONTROLLED ENTRIES/EXITS
This solution is recommended when you want to enter a reserved area in just one direction, by activating a command (radio control, proximity
key, magnetic keys, etc.).
Loops S1 and S2 also have a safety function in that they will not let the bollard to move all the time if the vehicle is over S1 or S2.
- Connect the N.O. contact of the S1 loop receiver to PDM input.
- Connect the N.O. contact of the S2 loop receiver to CLOSE input.
- The dimensional values given are approximate.
*
We suggest installing the "RME 2" metal mass loop detector.
PARAMETER





Control unit
INSTALLATION A
13.1
RECOMMENDED DIMENSIONS
DATA
DESCRIPTION

The close command acts as a close-when-release and safety function.

Radio channel 1: Open

Opening consent

Semiautomatic logic

Commands during pause is OFF
CONTROLLED ENTRY OR EXIT
- 37 -
The vehicle approaches the
reserved area.
When the vehicle is on the loop S1
the bollard will go down only after
a command (ex.: remote control).
If the bollard is closing and the
user wants to lower it again, the
vehicle must be over loop S1 and
the command must be repeated.
When the vehicle is no longer
over loop S2 the bollard will
close.
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido