melitta AROMAFRESH Instrucciones De Uso página 11

7.2 Cleaning the grinder
Note: You can call up cleaning and care
instructions by using the QR code.
Clean the grinder if you see visible soiling.
After each time you clean the grinder, you
should also clean the ground coffee chute.
GB
• Empty the bean container. Allow the grinder to
grind itself empty. Do this by fitting a filter in the
filter insert  and starting the grinding process
with the "Start/Stop" button .
• Turn the grinding fineness regulator until the two
triangles point towards each other . Pull the
grinding fineness regulator vertically upwards out of
the appliance .
• Clean all parts of the grinder with the brush.
• Clean the lower grinding disc , the gap  and the
entrance to the ground coffee chute
remove loose ground coffee with a vacuum cleaner.
Loosen caked-on ground coffee with the brush.
• Pull the silicone ring off the disc carrier .
• You can remove the ground coffee from the grinding
ring by tapping it lightly. You can also remove the
ground coffee with a vacuum cleaner. If it is heavily
soiled, you can clean the grinding ring under running
water. Allow the grinding ring to dry completely.
• Reassemble the grinding fineness regulator. Make
sure you press the silicone gasket evenly and as far
as it will go into the grinding ring.
• To lock the grinding ring, turn it to the position
shown .
• Insert the grinding fineness regulator vertically into
the appliance. The two triangles must point towards
each other . Turn the grinding fineness regulator
clockwise up to the stop to lock it.
Clean the ground coffee chute:
• Holding the appliance in both hands carefully lay it
on its back.
• Now you can firstly clean the area above the swivel
filter with the brush and a damp cloth.
• To open the ground coffee chute  hold down the
button for ground coffee o for 5 seconds.
• The ground coffee chute flap opens and the chute
can be cleaned with the brush..
• To close the flap on the ground coffee chute hold
down the button for ground coffee o for 5 seconds.
• Put the swivel filter j back in place and stand the
appliance up again.
Descaling:
Based on the water hardness you have set (see
point 3) the appliance should be descaled soon after
the CALC  indicator lights up.
• Measure out the descaling fluid according to the
manufacturers instructions and pour it into the
water tank. We recommend using Melitta
Calc Liquid for Filter Coffee & Aqua Machines".
• Briefly press the CALC button . The red LED
starts to flash .
• The current time and 'CALC' appear alternately in
the display .
• The descaling process runs automatically. To remove
even heavy calcification the descaling process takes
about 25 minutes.
• Attention: Only by running the complete descaling
process can all limescale deposits be removed. Only
then does the Calc LED  go off. Therefore the
11
descaling process should not be interrupted.
• After the descaling process has been completed the
light in the CALC button  goes off. The appliance
turns off automatically.
• To completely remove any deposits from desca-
ling, the appliance must be rinsed twice with the
maximum amount of water without coffee, after the
descaling process has ended. Proceed as described
in point 2.
8. Note on disposal
• Appliances labelled with this symbol
to European guidelines for WEEE (Waste Electrical
and Electronic Equipment).
• Electric appliances do not go in the household bin.
Dispose of the appliance in an environmentally
friendly way using suitable collection systems.
. You can
• Packaging materials are raw materials and can be
s
recycled. Please recycle them.
"Anti
®
are subject