Step 1
Assemble your unit on a carpeted fl oor or on the empty carton to avoid scratching your unit or the fl oor.
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (1) to the RIGHT UPRIGHT (C) and RIGHT END (D). Use six BLACK 1/2" FLAT HEAD
å
SCREWS (16).
NOTE: For each EXTENSION RAIL, turn three screws into the holes shown in the upper diagram. Slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other holes that lines up with the hole in the END. Turn a SCREW into
these holes.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Open end
This hole
must be
closer to
this edge.
423720
2
Push the black lever up and pull the SLIDE from the RAIL.
C
1
Slide the inner
cartridge to fi nd
these holes.
www.sauder.com/service
Look for this icon. It means a
video assembly tip is available at
www.sauder.com/service/tips
16
BLACK 1/2" FLAT HEAD SCREW
(6 used in this step)
1
D
1
Open end
This hole
must be
closer to
this edge.
Slide the inner
cartridge to fi nd
these holes.
Page 5