Joie Gemm and Juva Manual De Instrucciones página 2

Any questions for using gemm or juva, please refer to each manual
Installing with the base
Installation of ISOFIX
Base System
1. Unfold the load leg from storage
compartment.
1
2. If base used previously with
stages ISOFIX seat remove
TM
rebound bar as shown in
illustration
2
!
Store safely for future use with
stages TM ISOFIX seat. 3
1
1
2
2
1 1
3
3. After placing the base on the
vehicle seat, squeeze load leg
adjust button to extend the load
leg to floor -1, the load leg
4
indicator shows green means it
is installed correctly, red means
it is installed incorrectly. -2
4
!
The load leg has 24 positions.
When the load leg indicator
shows red this means the
load leg is in the wrong
position.
!
Make sure the load leg is fully
contact with the vehicle floor
pan.
!
The load leg must be installed
correctly with green indicator.
-2
4
!
Squeeze the load leg
releasing button, then shorten
the load leg upwards.
4
4. Fit the ISOFIX guides with the
ISOFIX anchor points. -1 The
5
ISOFIX guides can protect the
surface of the vehicle seat from
being torn. They can also guide
the ISOFIX connectors.
4
1
2
5
1
2