Publicidad
Idiomas disponibles
Idiomas disponibles
Control remote description
TEMP.
: Increases / Decreases
1
operating "TEMPERATURE".
POWER: Turns the power to the
2
main unit only. "on/off "
TIMER: Activates the "auto START"
3
or "auto STOP" program from 0-12
hours (1 hour increments).
SWING (some models): Activates
4
the automatic air "SWING" (vertical
louver oscillation) feature.
MODE: Activates the "AUTO" (if
5
applicable), "HEAT" (if applicable),
"COOL", "FAN" or "DRY" function.
FAN: Activates the "FAN" speed
6
settings (HIGH, MED,LOW).
SLEEP: Activates the "SLEEP"
7
mode.
Vertical air flow adjustment (manually)
To adjust vertical air flow direction,
adjust any one of the horizontal
louvre blades. When adjusting the
horizontal louver blades up or down,
always keep the top or bottom
blades horizontal. This can effectively
prevent water droplets condensing
on the front panel of the unit.
41
All manuals and user guides at all-guides.com
1
2
3
6
4
7
5
Cleaning and maintenance
Air filter
The air filter behind the inlet grille should
be checked and cleaned at least once
every 2 weeks (or as necessary) to
maintain optimal performance of the air
conditioner. If symbol "E1" displays in the
LED window, switch off and disconnect
the air conditioner from the power supply
and clean the filter.
How to remove the air filter
1. The grille may be opened from the
top or bottom for easy maintenance
after installation.
2. Open the inlet grille by pulling off the
exposed door on the bottom or top
of the unit (based on installation).
3. Pull the tab slightly to release the
filter. Pull the filter in the same
direction as the opening.
4. Clean the filter with warm, soapy
water. The water should be below
40 °C to prevent distortion of the
filter.
5. Rinse off and gently shake off
excess water from the filter. Allow
the filter to dry before replacing it.
To prevent distortion of the filter, do
not dry in direct sunlight.
Treatment of condensed water
To meet different requirement of different type of air conditioner, there are two
kinds of methods for your choice to treat the condensed water.
For cooling only models:
You can choose back drainage or non-drainage. See the following procedures
to perform back drainage:
42
Publicidad
