Descargar Imprimir esta página

Frigidaire FAW072A2BIW Manual De Instrucciones página 23

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Fit the seal onto the drain joint
(which provided with your air
conditioner accessory).
2. Remove the rubber plug from
the back of the unit.
3. Attach the drain joint to the back
of the cabinet where you remove
the plug and rotate 90° to
securely assemble them.
4. Connect the drain joint with a
extension drain hose (Locally
purchased)
For reverse cycle models:
You can choose bottom drainage. See
the following procedures to perform
bottom drainage:
1. Take out the drain pan and
screws (which provided with
your air conditioner accessory).
2. Install the drain pan at the
bottom of the unit and secure
with screws provide.
3. Connect the drain hose to the
outlet located at one side of the
drain pan. You can purchase the
drain hose or tubing locally to
satisfy your particular needs
(Drain hose is not supplied)
43
All manuals and user guides at all-guides.com
7 7
Central
Orifice
Drain Joint
Rubber plug
Seal
Cabinet
Drain
pain
Rubber
plug
Drain
outlet
Screw
Installation instructions
Select the best location:
1. To avoid vibration and noise, make sure the unit is installed securely and
firmly.
2. Install the unit where the sunlight does not shine directly on the unit. If the
unit receives direct sunlight, build an awning to shade the cabinet.
3. There should be no obstacle, such as a fence or wall, within 50cm from
the back of the cabinet because it will prevent heat radiation of the
condenser.
Restriction of outside air will greatly reduce the cooling and heating
efficiency of the air conditioner.
4. Install the unit a little obliquely outward not to leak the condensed water
into the room (about 10mm or 1/4 bubble with level).
5. The power cord must be connected to an independent circuit. The
yellow/green wire must be grounded.
6. Install the unit with its bottom portion 75~150cm above the floor level.
AWNING
FENCE
About 10mm
Over 50cm
AWNING
FENCE
About 10mm
Over 50cm
Attention
All side louvers of the cabinet must
remain exposed to the outside of the
structure.
44

Publicidad

loading