Connection With The Mains; Operation; Stand Alone Operation; Dmx-Controlled Operation - Futurelight WL-250 MK2 Manual Del Usuario

Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

Connection with the mains

The electric connection must only be carried out by a qualified electrician!
In order to connect the device to the mains, you have to install a power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
Connect the device to the mains with the power-plug.
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the WL-250 MK2 starts running. During the Reset, the motors
are trimmed and the device is ready for use afterwards.

Stand Alone operation

In the Stand Alone mode, the WL-250 MK2 can be used without controller.
Disconnect the WL-250 MK2 from the controller and from the mains and open it. Call up the internal
programs as follows:
In order order to select the programs, DIP-switch no. 10 must be set to ON, the programs are selected via
DIP-switches 1-3.
DIP-switch Program
10+1 1
10+2 2
10+1,2 3
10+3 4
10+3,1 5
10+3,2 6
10+3,2,1 7

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
DANGER TO LIFE!
International
L
N
Feature
Cyan only
Yellow only
Magenta only
CMY, fast change, short step time
CMY, fast change, long step time
CMY, slow change, short step time
CMY, slow change, long step time
20/43
resistor
00026452.DOC, Version 1.1