Dreame V11SE Manual Del Usuario página 12

Specifications
EN
Model VVA1
Charging Voltage 30 V
Rated Power 450 W
Multi-Brush Bar
Model AVB9
Rated Power 40 W
This product contains batteries that can only be replaced by qualified technicians or
after-sales service.
This product contains batteries that are non-replaceable.
WEEE Information
All products bearing this symbol are waste electrical and electronic
equipment (WEEE as in directive 2012/19/EU) which should not be mixed
with unsorted household waste. Instead, you should protect human
health and the environment by handing over your waste equipment to
a designated collection point for the recycling of waste electrical and
electronic equipment, appointed by the government or local authorities.
Correct disposal and recycling will help prevent potential negative
consequences to the environment and human health. Please contact the
installer or local authorities for more information about the location as
well as terms and conditions of such collection points.
20
Vacuum Cleaner
Charging Time Approx. 3.5 hours
Rated Voltage 25.2 V
Battery Capacity 2500 mAh
Mini Electric Brush
Model DM002
Rated Power 20 W
FAQ
If the vacuum is not working as expected, please refer to the troubleshooting table
below.
Errors Possible Causes
The vacuum is out of
battery or low on power.
Overheat protection mode
The vacuum
triggered by a blockage.
does not work
The suction opening or
airway passage is blocked.
Dust cup is full and/or HEPA
filter assembly is clogged.
Weak suction force
Attachment is blocked.
Main suction opening or
Motor is making
extension rod is blocked.
a strange noise
The first indicator
is red after
Battery pack is damaged.
turning on the
vacuum
The first indicator
blinks red after
Power adapter is incompatible.
charging the
vacuum
The adapter is not
connected to the vacuum.
Battery
The battery is fully charged
indicator does
and went into sleep mode.
not light up
while charging
If the problem persists after ruling out the above two
possibilities, please contact the after-sales service
department for maintenance.
The vacuum Battery temperature is too
charges slowly low or too high.
EN
Solutions
Fully charge the vacuum,
then continue to use it.
Wait until the vacuum cools
down, then reactivate it.
Clear any blockage from
suction opening or airway
passage.
Empty the dust cup and clean
the HEPA filter assembly.
Clear any blockage in the
attachment.
Clear any blockage in main
suction opening or extension
rod.
Please contact the after-sales
service department for
maintenance.
Only use the original power
adapter to charge the
vacuum.
Make sure the power adapter
is plugged in properly.
The vacuum can be used
normally.
Wait until the battery
temperature returns to
normal, then continue to use
the vacuum.
21