Roborock Q7 Max+ Manual Del Usuario página 11

Note: To prevent blockage, only use clean water without
any cleaning liquid.
C5-5—Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Do not touch the surface of the filter with your
Note:
hands, brush, or hard objects to avoid potential damage.
C5-6—Allow 24 hours for the filter to dry
thoroughly and reinstall it.
Purchase an additional filter and alternate if necessary.
Note:
Mop Cloth
C6
* Clean after each use and replace every 3-6 months
Remove the mop cloth from the mop cloth
mount. Clean the mop cloth and air-dry it.
A dirty mop will affect the mopping performance.
Note:
Clean it before use.
Dust Bag Replacement
C7
* Replace as needed
C7-1—Remove the dustbin cover vertically
as shown.
C7-2—Lift the dust bag out of the dustbin
and discard it.
Note: The dust bag handle seals the bag on removal to
prevent dust leakage.
C7-3—Clean the filter with a dry cloth.
C7-4—Install a new dust bag in place along
the slot and put the dustbin cover back.
Air Duct
C8
* Replace as needed
C8-1—Unscrew the screws (10) and remove
the cover.
C8-2—Wipe the air duct and cover with a
dry cloth.
C8-3—Reinstall the cover and screw it back
in place.
Robot Sensors
C9
* Clean monthly
Use a soft, dry cloth to wipe and clean all
sensors, including:
C9-1—Dock Locator
C9-2—Wall Sensor
C9-3—Four Cliff Sensors
Charging Area Cleaning
C10
* Clean as needed
Clean the dock location beacon, charging
contacts, and electrode brushes with a dry cloth.
Battery
The robot is equipped with a high-performance
lithium-ion rechargeable battery pack. To
maintain battery performance, keep the robot
charged during normal use.
Note: If the robot will be left unused for a long period,
turn it off and charge it at least every three months to
avoid battery damage caused by over-discharge.
11
Basic Parameters
Robot
Model Q380RR
14.4V/5200mAh
Battery
lithium-ion battery
Weight Approx. 4.7kg (10.36 lbs)
Rated Input 20VDC 1.2A
Charging Time < 6 hours
Note: The serial number is on a sticker on the underside
of the robot.
Auto-Empty Dock
Model AED03LRR
Rated Input Voltage 120VAC
Rated Frequency 50-60Hz
Rated Input
9.5A
(Dust Collection)
Rated Input (Charge) 0.5A
Rated Output 20VDC 1.2A
14.4V/5200mAh
Charging Battery
lithium-ion battery