Publicidad
Idiomas disponibles
Idiomas disponibles
5.4 ACTIVATION
To activate the system
Button
Function
Press the ON stand-by button for 2 sec.
Select one of the 3 function modes by pressing the relevant button.
5.5 SETTING THE CONDITIONING/HEATING OPERATING MODE
Button
Function
Hold down the Heating / Chilling button for approx. 2 seconds to switch the operating
mode from heating to cooling, which can be seen when the two symbols, heating or
cooling on.
In heating mode, the symbol is on with a high set point, above ambient temperature, while
both are switched off with lower set point.
In cooling mode, the symbol is on with a set point below ambient temperature, while both
are off with a higher set point.
If one of the 2 symbols flashes, this means that the water temperature (hot or cold) is not met
and this will cause the ventilator to stop until the temperature has reached a suitable value to
meet the request.
5.6 STANDBY
Button
Function
Hold down the ON standby button for approx. 2 seconds. The lack of any lit signal on the
display means that the "standby" status is on (no function).
When the control is in this operating method, it guarantees anti-freeze protection. If the room
temperature drops below 5°C, the hot water, the hot water solenoid is activated.
60
Display
ON
Display
Display
OFF
Publicidad
