EINHELL AQUINNA 36/38 F LED AUTOMATIC Manual De Instrucciones página 21

display (Fig. 4 / Item D2).
Important!
Selecting BOOST mode will increase the maxi-
mum delivery pressure and the maximum delivery
rate, but it will also reduce the maximum opera-
ting time.
6.3 Status LEDs (Fig. 4)
The current operating status is signaled via the
LED indicator (Fig. 4/Item C2).
Yellow and green are lit:
The pump is in operation and starts up as soon
as a consumer is opened for drawing off pumped
medium.
Yellow is lit and green is fl ashing:
The pump is building up pressure (e.g. a water
tap is closed) and then switches off automatically.
Yellow, green and red are lit:
The pump is running dry without any pumped
medium. The pump will make 3 attempts to elimi-
nate the dry running before the dry running guard
fi nally trips.
Yellow and red are lit:
The dry running guard has tripped; it is no longer
possible to draw in the pumped medium. Use the
troubleshooting instructions to fi nd the cause of
the fault (e.g. a leaking intake line) and rectify it.
Then press the ON/RESET button (Fig. 4/Item
C1) to reactivate the pump.
6.4 Intake pressure gauge
If the pump has been started up correctly it will
pump water, and the indicator on the intake pres-
sure gauge in the coarse fi lter screw will rise to
the corresponding suction height. During operati-
on the current suction height can be read off the
intake pressure gauge (3). (Fig. 5)
If the pump fails to pump any water when a pri-
ming attempt is made and the value on the intake
pressure gauge stagnates or stays at 0 m, this
means that there is a problem on the intake side.
Check all connections and the suction hose for
possible leaks. Filling the pump with water can
help the priming attempt. As a basic principle we
recommend the use of a suction set with suction
hose, intake cage and non-return valve.
Anl_Aquinna_36_38_F_LED_Automatic_SPK13.indb 21 Anl_Aquinna_36_38_F_LED_Automatic_SPK13.indb 21
GB
7. Cleaning, maintenance and
ordering spare parts
The equipment almost completely maintenance
free. In order to ensure a long service life,
however, we recommend regular checks and
product care.
Danger!
Always remove the batteries before starting any
cleaning work.
7.1 Maintenance
•
If the equipment becomes clogged, connect
the discharge line to the water line and
disconnect the intake line. Open the water
line. Switch on the equipment several times
for approx. two seconds. This should resolve
the majority of clog-related problems.
•
There are no other parts inside the equipment
which require maintenance.
7.2 Cleaning the coarse fi lter insert
•
Clean the coarse filter insert at regular inter-
vals, and replace it if necessary.
•
Remove the coarse filter cap (3) and the
coarse filter (10) (Fig. 2).
•
Clean the coarse filter by tapping it on a flat
surface.
•
Wash the coarse filter under flowing, clear
water.
•
In cases of stubborn dirt, first wash with
soapy water, then rinse with clear water and
leave to dry in the air.
•
Do not use abrasive cleaning agents or petrol
to clean the coarse filter.
•
Assemble in reverse order.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
- 21 -
13.12.2022 07:05:04 13.12.2022 07:05:04