2. Touch the icon corresponding to the drink you want
to prepare for 3 seconds.
3. A beep will be heard. The Indicator of the maximum
setting of the icon
will light up and the indica-
tor of the icon
will flash.
4. Touch the icon
. The selected drink will be prepared as usual, until the icon
is touched again.
Then, water flow will stop and this water volume will be recorded as user personal
choice.
NOTE: water volume range for each kind of drink is:
- Espresso / Steam: 1 - 230ml
- Coffee / Hot Water: 1 - 430ml
It is recommended to fill the water tank previously up to the maximum level to be able to adjust the
maximum volume
Maximum water volume
Drink
indicator
5. After some seconds, all the indicators will light up again.
78
Factory default maximum
Personal choice maxi-
volume ml
mum volume ml
70
1 - 230
200
1 - 430
360
1 - 430
46
1 - 230
3.4. Activating water filter
If the filter is used, the period of time between descaling processes gets increased, so it is recommended
to enable it so that the coffee maker recognizes that it is installed.
By default, water filter comes disabled from factory.
To enable it, while the coffee maker is plugged in, proceed as indicated below:
1. If the coffee maker is switched on, touch the
icon
to switch it off.
All the indicators will go off.
2. Touch the icon
for 3 seconds.
a) A long beep and Indicator flashing means that filter is disabled.
b) Three short beeps and Indicator on means that filter is enabled.
3. Touch the icon
to switch from enabled to disabled mode and
vice versa.
4. Touch the icon
to confirm the selection.
All the indicators will go off.
3.5. Setting auto shut off time
For your safety and to save energy, the coffee maker switches off automatically when it has not been
used for a period of time. Switch off period is 15, 30, 60 or 180 minutes.
To select it, while the coffee maker is plugged in, proceed as indicated below:
1. If the coffee maker is switched on, touch the icon
to switch it off.
All the indicators will go off..
79