To Advance The Cutting Line - Ryobi RY252CS Manual Del Operador

TO ADVANCE THE CUTTING LINE

(REEL-EASY STRING HEAD)
™
Line advance is controlled by tapping the string head on
grass while running engine at full throttle.
 Run engine at full throttle.
 Tap the knob on ground to advance line. The line advances
each time the knob is tapped. Do not hold the knob on
the ground.
NOTE: The line trimming cut-off blade on the grass deflector
will cut the line to the correct length.
NOTE: If the line is worn too short you may not be able to
advance the line by tapping it on the ground. If so, stop the
engine and manually advance the line.
To advance the cutting line manually:
 Stop the engine and disconnect the spark plug wire.
 Push the knob in while pulling on line(s) to manually ad-
vance the line.
OPERATION
GRASS DEFLECTOR LINE TRIMMING CUT-
OFF BLADE
See Figure 12.
The trimmer is equipped with a line trimming cut-off blade
on the grass deflector. For best cutting, advance line until it
is trimmed to length by the cut-off blade. Advance the line
whenever you hear the engine running faster than normal,
or when trimming efficiency diminishes. This will maintain
best performance and keep the line long enough to advance
properly.
9 — English