SK magic BID-S24D Manual De Instrucciones página 13

CAUTION
Don't allow water to come in contact with the Bidet seat.
•
Make sure to use a grounded outlet.
•
After installation, check if water is leaking from each connecting parts (Water Supply Hose,
•
Shutoff Valve etc.).
When installing in a place where the temperature of the bathroom in winter goes below
•
freezing, insulate the water supply pipe.
Never connect the power if the product is not installed.
•
How to Remove
(rev00) BID-S24D_User_EN+MES.indb 13 (rev00) BID-S24D_User_EN+MES.indb 13
Connect the Power plug of Bidet seat.
•
-
-
To remove the product from the Toilet bowl,
hold the both sides of the product while
pressing the button at the bottom right of the
product and pull it forward to lift it.
Button
After 1 ~ 2 minutes, water fills and flows out
of the middle hole of the Bidet seat (Nozzle
hole).
Don't connect the power plug before
supplying water.
English 13
2021-06-07 2021-06-07 2:07:43 2:07:43