Publicidad
Idiomas disponibles
Idiomas disponibles
Detection (seat sensor) is turned off for the child function.
Children should be supervised to ensure that they don't play with the product.
•
The bidet is activated and water is sprayed. (The spray of water may make the floor or
•
interior slippery and cause injury)
If traveling, or if the product will not be in use for a long time, unplug the power plug and
drain all the water out of the tank.
Otherwise, property damage may occur due to fire, etc.
•
Do not allow water droplets to appear or water to splash the product's surface.
Also, when using the product in a humid place such as a bathroom, install a fan to ensure
good ventilation.
Failure to do so may cause an electric shock or fire.
•
The power plug must be unplugged when cleaning the product's interior and exterior, or
when removing the product.
Failure to do so may cause an electric shock.
•
Periodically clean the power plug and check that it is inserted safely.
If water leaks from the water supply parts, turn off the Shutoff Valve, unplug the power plug,
and contact SK magic Service Center.
Failure to do so may cause an electric shock or fire.
•
Those who are unable to use the product safely without supervision or instruction due to lack
of physical, sensory, or mental abilities, or due to lack of experience or knowledge (children
included), or those who have sensitive skin or a disease in the area to be cleaned (rear, etc.),
should adjust the water pressure, warm water temperature, and drying temperature to a
lower setting with help from someone around you.
When set to a high temperature, beware that low-grade burns may occur because the high
•
temperature may not be felt.
If the bidet water pressure is high, there may be a risk of anal bleeding, sphincter weakness,
•
etc.
Low-grade burns refer to burns with no observable symptoms that occur when in contact with a
-
low heat for a long time.
When sitting for a long time on the toilet seat, turn off the toilet seat heater and set the air
•
drying temperature to a low temperature.
Make sure to connect the product to the cold water pipe.
Failure to do so may cause burns or product damage.
•
Do not use the product if it is broken, and never repair or disassemble the product.
Failure to do so may cause an electric shock or fire.
•
Immediately unplug the power plug, and turn off the Shutoff Valve.
•
Do not operate the product if it has a damaged cord or plug, is not working properly, has
•
been dropped or submerged in water. Contact SK magic Service Center to get it inspected.
4 English
(rev00) BID-S24D_User_EN+MES.indb 4
(rev00) BID-S24D_User_EN+MES.indb 4
2021-06-07
2021-06-07
2:07:42
2:07:42
Publicidad
