Publicidad
Idiomas disponibles
Idiomas disponibles
Before Use
120 V
(rev00) BID-S24D_User_EN+MES.indb 17
(rev00) BID-S24D_User_EN+MES.indb 17
1. After checking the voltage, plug the power plug into a 120
outlet.
The lamps on the control panel light up.
•
Use an outlet attached to a ground terminal.
•
2. Please open the seat cover and sit down.
NOTE
Using the seat sensor. It can be operated only when someone is sitting
•
to prevent malfunction. (Doesn't apply to child function)
3. Set the water temperature, seat temperature, water pressure,
and drying temperature on the control panel.
Water temperature - Press the [WATER TEMP.] button to set the
•
water temperature.
Each time the [WATER TEMP.] button is pressed, it selects in
-
the order of Low (green), Medium (orange), High (red), and
OFF.
It is set to OFF when first connected to power.
-
Seat temperature - Press the [SEAT TEMP.] button to set the seat
•
temperature.
After the initial setup, it takes 4 to 5 minutes to warm up.
-
Each time the [SEAT TEMP.] button is pressed, it selects in the
-
order of Low (green), Medium (orange), High (red), and OFF.
The seat is set to OFF when first connected to power.
-
Water pressure - Press the [PRESSURE] button set the strength.
•
Each time the [PRESSURE] button is pressed, it changes in the
-
order of Low (green), Medium (orange), High (red).
The water pressure is set to Medium (level 2) when first
-
connected to power.
Drying temperature - Press the [DRY] button set the temperature.
•
Press the [DRY] button to operate it.
-
While drying, press [DRY] button and it will change in the
-
order of Low (green), Medium (orange), High (red).
The dryer is set to Medium (level 2) during the initial
-
operation.
V
English 17
2021-06-07
2021-06-07
2:07:44
2:07:44
Publicidad
