Publicidad
Idiomas disponibles
Idiomas disponibles
Gas connection on the appliance
Connecting pieces
Default setting of the burners
The burners are set up for G30 liquefied gas on delivery.
Connecting to liquefied gas
If you connect the appliance to liquefied gas, you must always install a suitable gas pressure regulator.
Use the total gas consumption of the appliance stated on the rating plate to select a suitable gas pressure
regulator.
Only use connecting lines or flexible hoses which comply with the applicable regulations and which are
approved for this purpose.
Flexible hose
Description
LPG corrugated tube union (and seal)
Proceed as follows:
• Screw the corrugated tube union (C) and the seal (B) to the gas
connection (A).
• Hold the corrugated tube union (C) in place with a spanner and
screw the connecting piece to a flexible gas connecting hose (E).
• Tighten the clamp (D).
Only use approved sealing compound to seal the
thread.
If you use flexible hoses, make sure that: the hoses do not become
trapped or squashed.
• the hoses are not subject to twisting or pulling forces.
• the hoses do not come into contact with sharp edges or cutting
edges.
• the hoses do not come into contact with parts that could reach a
temperature higher than 70 °C above room temperature.
Ensure that the full length of the hoses are accessible for
inspection.
En g li s h -5
Publicidad
