Kärcher KM 35/5 C Manual Del Usuario página 10

Attach the strut and the handle
see Figure 2
The strut consists of 3 parts. While assem-
bling it, make sure that the parts lock into
each other.
Assemble the strut parts.
Mount handle onto strut.
Insert the entire strut with the locking
button into the joint on the appliance.
Charge the battery
see Figure 3
The battery is precharged at the time of deliv-
ery. Charge it after work and when needed.
Note
The battery can be charged only when it is
removed out of the appliance.
Connect battery with charger using the
charger cable.
Insert the charger delivered with the ap-
pliance into a proper socket.
The charger display blinks green. The bat-
tery is being charged.
Charging current for empty battery
Quick charger
Note
If the charging time is exceeded, the charg-
er shifts to retention charging. The charger
display blinks green.
Note
Disconnect the charger from the mains af-
ter the charging process is complete to re-
duce energy use.
Replacing the battery
see Figure 4
Press the lock release button and pull
the battery out toward the rear.
Insert the replacement battery into the
intake and lock it.
Note
Please properly dispose of defective or
damaged batteries. Use only original
KÄRCHER replacement batteries (order
no. - see optional accessories).
10
see Figure 5
Switch on the appliance; press the on/
off foot switch to do so.
Move the appliance forward to clean it.
Use the right side (battery side) to clean
the appliance close to the edges.
Tilt the appliance to pick up larger ob-
jects. Use the kick plate for this.
see Figure 6
Switch off the appliance; press the on/
off foot switch to do so.
To ensure that the appliance's strut
stands safely during breaks in opera-
tion, hold it vertically; there is a stopper
that holds it in position.
Switch off the appliance when finished.
Empty dirt container after each cleaning.
Press the unlocking button of the bat-
4h
tery and remove the battery.
Place the appliance into its storage po-
sition.
Charge the battery.
see Figure 7
Unlock the dirt container and remove it.
Empty the dirt container.
Insert and lock into place the dirt con-
tainer.
see Figure 8
The appliance must be stored upright
on its back.
Store the appliance in a dry room.
3
-
EN
Operation
Starting the work
Interrupting the work
Finishing your work
Emptying the dirt container
Storing the appliance