Publicidad
Idiomas disponibles
Idiomas disponibles
6
PROPOSITION 65
WARNING
This product contains a chemical known to the
state of California to cause cancer, birth defects
or other reproductive harm. Some dust created by
power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• Lead from lead-based paints;
• Crystalline silica from bricks and cement and
other masonry products;
• Arsenic and chromium from chemically treated
lumber.
Your risk of exposure to these chemicals varies
depending on how often you do this type of work. To
reduce your exposure to these chemicals, work in a
well-ventilated area, and work with approved safety
equipment, such as dust masks that are specially
designed to filter out microscopic particles.
Save these instructions.
7
INSTALLATION
WARNING
Do not use accessories that are not recommended
by the manufacturer.
WARNING
Do not put in the safety key or the battery pack until
you finalized the assembly of all the parts.
7.1
UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If parts of the machine are damaged, do not use
the machine.
• If parts are missing, do not operate the machine.
• If parts are damaged or missing, contact the
service center.
1.
Open the package.
2.
Read the documentation provided in the box.
3.
Remove all the unassembled parts from the box.
4.
Remove the machine from the box.
English
5.
Discard the box and packing material in
compliance with local regulations.
For your personal safety, do not insert battery before
the tool is assembled completely.
7.2
INSTALL THE UPPER HANDLE
13
1.
Align the holes in the upper handle (4) and the
lower handle (5).
2.
Put the bolts (14) through the holes.
3.
Tighten the knobs (13) onto the bolts.
4.
Do the same operation on the other side.
7.3
UNFOLD THE LOWER HANDLE
1.
Pull and turn the handle knobs (15) 90°.
2.
Unfold the handle.
3.
Line up the handle knobs in one of the three
positions (P) on the brackets.
4.
Turn the handle knobs 90° until they engage the
holes in the brackets.
Make sure that the two handle knobs are in the
same position.
9
WARNING
4
13
14
5
15
P
NOTE
EN
Publicidad
