Panasonic ER-GP30 Manual Del Operador página 11

Care
Removing and mounting the blade
• Make sure that the clipper is turned off.
Removing the blade
Hold the clipper with the switch facing
upward and push the blade with your thumb
while catching the blade in your other hand.
Mounting the blade
Fit the mounting hook into the blade mounting on the clipper and
push in until it clicks.
Cleaning
• Clean the clipper and the blade after each use.
(If not cleaned, the motion will become poor and the sharpness
will worsen.)
• Make sure that the clipper is
turned off.
1. Brush off any hairs from the
clipper and from around the
blade.
ER-GP30_US.indb 11
2. Brush off the hairs from the
blade edge.
3. Brush the hairs out from between
the stationary blade and the
moving blade while pressing
down on the cleaning lever (a)
to raise the moving blade.
Lubrication
• Apply the oil to the clipper before and after each use.
Apply a drop of the oil to each
indicated point.
Attach the blade to the main
body, turn on the power and
allow to run for approximately
5 seconds.
Failure to apply the oil may
cause the following problems
due to rust, wear or burn out.
- The clipper has become blunt.
- Shorter operating time.
- Louder sound.
► Replacement parts
Replacement part is available at your dealer or Service Center
Replacement parts for ER‑GP30

Blade WER9701
11
2016/06/06 19:39:57