Panasonic ER-GP30 Manual Del Operador página 12

Troubleshooting
Problem
The clipper has become
blunt.
Operating time is short.
Clipper stopped
functioning.
The clipper cannot be
charged.
Makes a loud sound.
If the problems still cannot be solved, contact the store where you
purchased the appliance or a service center authorised by
Panasonic for repair.
12
ER-GP30_US.indb 12
Action
Until problems are solved, please
follow each procedure as follows;
1. Charge the clipper.
(See page 9.)
2. Clean the blade and apply oil.
(See page 11.)
3. Replace the blade.
(See page 11.)
4. Have the battery replaced by an
authorized service center.
Insert the appliance plug into the
clipper firmly.
Charge within the recommended
charging temperature of 0 °C
(32 °F) to 35 °C (95 °F).
Apply oil.
(See page 11.)
Have the battery replaced by an
authorized service center.
Removing the built-in rechargeable battery
ATTENTION:
A nickel metal hydride battery that is recyclable powers the
product you have purchased. Please call 1‑800‑8‑BATTERY for
information on how to recycle this battery.
Remove the built-in rechargeable battery before disposing the
clipper.
This figure must only be used when disposing the clipper, and
must not be used to repair it. If you dismantle the clipper yourself,
it may cause malfunction.
• Remove the clipper from the AC adaptor.
• Slide the power switch to turn on the power and then keep the
power on until the battery is completely discharged.
2016/06/06 19:39:57