GreenWorks PS24B00 Manual Del Propietário página 3

SAFETY RULES
Save all warnings and instructions for future reference.
The term "power tool" in all of the warnings listed below refers to your mains-operated (corded)
power tool or battery-operated (cordless) power tool.
GENERAL SAFETY RULES
• Avoid Dangerous Environment – Don't use appliances in damp or wet locations.
• Don't Use In Rain.
• Keep Children Away – All visitors should be kept at a distance from work area.
• Dress Properly – Do not wear loose clothing or jewelry. They can be caught in moving parts.
Use of rubber gloves and substantial footwear is recommended when working outdoors. Wear
protective hair covering to contain long hair.
• Use Safety Glasses – Always use face or dust mask if operation is dusty.
• Use Right Appliance – Do not use appliance for any job except that for which it is intended.
• Don't grasp the exposed cutting blades or cutting edges when picking up or holding the
appliance. (For grass shears and similar appliances only.)
• Don't Force Appliance – It will do the job better and with less likelihood of a risk of injury at the
rate for which it was designed.
• Don't Overreach – Keep proper footing and balance at all times.
• Stay Alert – Watch what you are doing. Use common sense. Do not operate appliance when
you are tired.
• Disconnect Appliance – Disconnect the appliance from the power supply when not in use,
before servicing, when changing accessories such as blades, and the like.
• Store Idle Appliances Indoors – When not in use, appliances should be stored indoors in dry,
and high or locked-up place – out of reach of children.
• Maintain Appliance With Care – Keep cutting edge sharp and clean for best performance
and to reduce the risk of injury. Follow instructions for lubricating and changing accessories.
Inspect appliance cord periodically, and if damaged, have it repaired by an authorized service
facility. Inspect extension cords periodically and replace if damaged. Keep handles dry, clean,
and free from oil and grease.
• Check Damaged Parts – Before further use of the appliance, a guard or other part that is
damaged should be carefully checked to determine that it will operate properly and perform
its intended function. Check for alignment of moving parts, binding of moving parts, breakage
of parts, mounting, and any other condition that may affect its operation. A guard or other
part that is damaged should be properly repaired or replaced by an authorized service center
unless indicated elsewhere in this manual.
POLE SAW SAFETY RULES
• Keep all parts of the body away from the saw chain. Do not remove cut material or hold
material to be cut when blades are moving. Make sure the switch is off when clearing jammed
material. Saw chain continues to move after the switch is turned off. A moment of inattention
while operating the pole saw may result in serious personal injury.
• Carry the pole saw by the handle with the saw chain stopped. When transporting or storing
the pole saw, always fit the saw chain device cover. Proper handling of the pole saw will
reduce possible personal injury from the saw chain.
3