Publicidad
Idiomas disponibles
Idiomas disponibles
Tips for Best Trimming Results
(Fig . 15)
The correct angle for the cutting attachment
•
is parallel to the ground.
Do not force the trimmer. Allow the very tip
•
of the line to do the cutting (especially along
walls). Cutting with more than the tip will re-
duce cutting efficiency and may overload the
motor.
The cutting height is determined by the dis-
•
tance of the cutting line from the lawn sur-
face.
Grass should be cut by working progressively
•
from top to the bottom in small increments to
avoid premature line wear or motor drag.
Slowly move the trimmer into and out of the area being cut, maintaining the cutting head po-
•
sition at the desired cutting height. This movement can be either a forward-backward motion
or a side-to-side motion. Cutting shorter lengths produces best results.
Trim only when grass and weeds are dry.
•
Wire and picket fences can cause extra string wear or breakage. Stone and brick walls,
•
curbs, and wood may wear strings rapidly.
Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts can easily be
•
damaged by the strings.
To Adjust Cutting Line Length
The trimmer head allows the operator to
release more cutting line without stopping
the motor. As line becomes frayed or worn,
additional line can be released by lightly
tapping the trimmer head on the ground while
operating the trimmer (Fig. 16).
WARNING
assembly . Excessive line length will cause the
motor to overheat and may result in serious
personal injury.
For best results, tap the trimmer head on bare
ground or hard soil. If line release is attempted
in tall grass, the motor may overheat. Always
keep the trimming line fully extended. Line release becomes more difficult as the cutting line
becomes shorter.
Do not remove or alter
the line-cutting blade
Fig. 15
Dangerous Cutting Area
Fig. 16
Best Cutting
Area
21
Publicidad
