Barrette Rail Instrucciones De Instalación página 10

9.
Installing Brackets:
NOTE:
There is a separate screw pack for the top rail
and bottom rail brackets.
a. Slide your angle brackets top/bottom onto
your rails and place your stair rail section
between your posts on top of your temporarily
secured deck board (Fig. 10).
b. Mark all bracket holes (Fig. 11).
c. Remove stair railing section.
d. Remove temporarily secured deck board.
e. Pre-drill all bracket holes with a
(Fig. 12).
f. On your top railing brackets position a drill
bit on center of post (2" from either side) and
between previously drilled four screw holes.
Pre-drill using
the steel insert (Fig. 13).
g. If using a Post Install Kit, attach a 2" screw
into the post all the way through into the steel
insert. If using a wooden post with a Post
Jacket, drive a 2" screw into the wood post.
10.
Railing to Posts:
a. Slide stair railing section with brackets back
in-between posts.
b. Add #10 x 1
secure stair railing section to posts (Fig. 14).
10
1 1 1
⁄ ⁄ ⁄ " drill bit all the way through ⁄
5 5 5
32 32
⁄ ⁄ ⁄ ⁄ " mounting screws to brackets to
1 1 1
4 4
⁄ " drill bit ⁄ ⁄ ⁄
8 8
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14