Publicidad
Idiomas disponibles
Idiomas disponibles
Reversible door
If required, the door may be reversed, i.e. from right-hinged
(default installation) to left-hinged.
Warning: Always disconnect the unit from the mains
before any maintenance or repair work is carried out.
1.
Remove the hinge cover (3) on the top of the
appliance.
2.
Remove the two screws (2) securing the upper hinge
(4) to the housing. Then lift off the hinge.
3.
Carefully lift up the door (5) and place it on a soft
surface to protect it from scratches.
4.
Remove the cover (1) for the hinge mounting holes
on the opposite side of the appliance and fit it in the
corresponding holes on the hinge side. Ensure that
the cover is firmly pushed down into the hole.
5.
Remove the adjustable foot (8).
6.
Remove the two screws (7) on the lower hinge plate
(6) and take the plate off.
7.
8. Install the lower hinge plate with the hinge pin facing
up on the other side. Do not yet tighten the screws!
8.
Screw the adjustable foot on the other side.
9.
Replace the door in its new position. Ensure that the
hinge pin is inserted into the guide bushing (hole) on
the lower part of the door.
10. Install the upper hinge on the closed door. Ensure that
the hinge pin is inserted into the guide bushing (hole)
on the upper part of the door. Caution: Do not yet
tighten the screws.
11. Adjust the closed door to its proper position and
tighten the screws of the upper and lower hinge plates.
12. Replace the hinge cover on the upper hinge.
13. Put the unit back in its intended position and wait for
about four hours before connecting it to the mains.
14
Temperature control
The unit is activated by connecting it to the mains. It is only
switched off completely when the plug is removed from the
wall socket.
The temperature in the cabinet can be adjusted by setting
the temperature control located at the rear.
1
means low cooling capacity and higher temperature in
the freezer box.
5
means high cooling capacity and low temperature in
the freezer box.
We recommend setting the control initially to position 3.
After a certain time, the actual temperature should then
be checked with a thermometer, and adjustments made if
necessary.
Note: The operating temperature in the freezer largely
depends on factors such as the ambient temperature and
that of the food to be newly frozen. It also depends on how
often the door is opened and how long it remains open. If
necessary, the temperature control setting may be adjusted
accordingly.
Following a power interruption, or if the unit has been
switched off on purpose, it may take 3 to 5 minutes before
it switches on again.
Freezer door
To ensure that frozen food will not de-frost prematurely, the
freezer door should be kept closed at all times. This will
also prevent an undue build-up of ice and frost. Ensure,
therefore, that the door is only opened briefly to place food
inside or to remove it.
Freezing and storing food
∙ The temperature inside freezer cabinet depends mainly
on the ambient temperature, the temperature control
setting and the amount of food stored.
∙ This freezer unit is designed for deep-freezing and long-
term storage of deep-frozen food, as well as for making
ice-cubes.
∙ Prior to freezing, fresh food (e.g. meat, fish, minced
meat) should be divided into smaller portions suitable for
use after defrosting).
Publicidad
