All manuals and user guides at all-guides.com
EN
Cleaning the burner cap
The surface of the burner cap and the fire hole are recommended to be cleaned at least
once a month. In particular, if the flame is uneven or if there is no flame in the individual
fire trough, please remove the burner cap and clean it. Use steel needle to remove the
dirt and carbon deposit in the flame hole..
Please do not flush the burner cap directly with water. Please make sure the burner cap
is dry before using it again.
Cleaning the ignition needle and thermocouple
Please use a soft brush to clean the surface of the ignition needle and the thermocouple.
Please do not bump the ignition needle when cleaning. After cleaning, please make sure
all parts are dry, then install the hob, burning head and fire cover correctly according
to the "Installation Instructions". Warranty will not cover the case if panel surface is
scratches or the burner cap assembly is deformed due to improper installation
31