Rowenta DA1500 Manual De Instrucciones página 36

IMPORTANT RECOMMANDATIONS
• The voltage of your electrical installation must correspond to that of the iron (220-
240V). Always plug your iron into an earth socket. Connecting to the wrong voltage
may cause irreversible damage to the iron and will invalidate the guarantee.
• If you are using a mains extension lead, ensure that it is corrected rated (16A) with
an earth, and is fully extended.
• If the electric power cord is damaged, it must be replaced by an Approved Service
Centre in order to prevent any danger.
• Do not unplug your appliance by pulling on the cord.
• Never immerse your steam iron in water or any other liquid. Never hold it under the
water tap.
• Never touch the electric cord with the soleplate of the iron.
• Your appliance gives off steam, which may cause burns, especially when you are
ironing close to the edge of your ironing board.
• Never direct the steam towards people or animals.
• For your saftey, this appliance conforms to the applicable standards and regulations
(Low Voltage, Electromagnetic Compatibility, Environmental Directives).
• This product has been designed for domestic use only. Any commercial use,
inappropriate use or failure to comply with the instructions, the manufacturer accepts
no responsibility and the guarantee will not apply.
ENVIRONMENT PROTECTION FIRST !
Your appliance contains valuable materials which can be recovered or
recycled.
Leave it at a local civic waste collection point.
DESCRIPTION
1. Voltage selector
(120/240 V)
2. Temperature control
Steam switch
3.
4. High precision tip
BEFORE IRONING
Remove the sticker on the soleplate.
Adjust the voltage selector.
• Adjust the iron to correct voltage for
your location, using a sharp object.
If the voltage selected is 120 V, the iron
will operate at 100 to 120 V.
If it is set at 240 V, the iron will operate
at 200 to 240 V.
Note!
If necessary, check that you are using an adapter which meets the safety
requirements of the country you are in.
Put the handle into the ironing position.
• Press the release button on the`
rear side and raise the handle
until it locks into position.
• For storing proceed in the same
way to close the handle.
STEAM IRONING
Filling the water tank.
Keep these instructions
5. Microsteam200 soleplate
6. Handle water tank
7. Water filling inlet
Burst of steam button
8.
9. Handle release
4