Fanimation FLORID LP8300 Serie Manual Del Usuario página 13

How to Install Your Canopy Housing
NOTE: This step is applicable after the necessary
wiring is completed.
1. Assemble canopy by rotating key slot in canopy
over shoulder screw in hanger bracket, taking care not
to pinch the wires. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that was
previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket
utilizing the key slot twist-lock feature. (Figure 2)
How to Assemble Your Adapter-Switch Cup
1. Disassemble the adapter-switch cup assembly by
removing three screws. (Figure 1)
NOTE: Make sure to keep loose hardware separate
to avoid confusion during installation.
2. Remove one of the three screws in the support
bracket at the bottom of the motor assembly and
retain the screw for later and slightly loosen the
remaining two screws. (Figure 2)
NOTE: Make sure to keep loose hardware separate
to avoid confusion during installation.
Motor
Assembly
13
Ceiling
Canopy
Figure 1
Canopy Screw
Cover
Figure 2
Adapter-Switch Cup
Assembly
Figure 1
Figure 2