Fanimation FLORID LP8300 Serie Manual Del Usuario página 7

How to Assemble Your Ceiling Fan Blades (Continued)
2. Remove the two set screws and locking nuts of the
downrod support from the motor assembly then retain
the screws and nuts for How to Assemble Your
Ceiling Fan, Step 4. (Figure 2)
3. Remove the six preassembled screws of the motor
coupler washer from the motor assembly, then retain
the screws for reinstallation in Step 7. (Figure 3)
4. Lift away the motor coupler washer and upper
housing cover from the motor assembly and set aside.
(Figure 4)
5. Slide the blade through the slot in the motor
assembly and attach to the motor hub using the
3/16˝-24 serrated head screws and flat washers.
Tighten serrated head screws with flat washers to
secure the blade to the hub of motor assembly.
(Figure 5)
NOTE: Make sure the bottom edge of the blade is fully
seated against the flywheel of motor assembly.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
Motor
Assembly
Upper Housing
Cover
Motor
Assembly
3/16"-24
Serrated Head Screws
Flat Washers
7
Downrod Support
Figure 2
Figure 3
Motor Coupler
Washer
Figure 4
3/16"-24
Serrated Head Screws
and Flat Washers
(3 each per blade)
Figure 5
HARDWARE USED:
Motor
Assembly
Blade
x 15
x 15