Publicidad
Idiomas disponibles
Idiomas disponibles
How to Assemble Your Ceiling Fan (Continued)
3.
Route the black and white wires through the
downrod. (Figure 3)
4.
Thread downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes in
the downrod support with holes in the downrod. Secure
clevis pin with hairpin clip. Install and tighten the two
previously removed set screws with locking nuts in the
downrod support. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
5. Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 5)
6. Reinstall the hanger ball on the downrod as follows.
Route the black and white wires through the hanger
ball. Position the pin through the two holes in the
downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin. Securely
tighten the set screw in the hanger ball. A loose set
screw could create fan wobble. (Figure 6)
7. Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2 inch
from the end of each lead wire. (Figure 7)
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
Downrod
Hairpin Clip
Clevis Pin
Motor Coupling
Cover
9
Black and White Wires
Downrod
Figure 3
Set Screws and
Locking Nuts (2)
Figure 4
Ceiling Canopy
Canopy Screw
Cover
Figure 5
Figure 6
Figure 7
Publicidad
