Publicidad
Idiomas disponibles
Idiomas disponibles
A standard US type sensor is used:
Impedance (fuel tank empty position) 30 Ohm
Impedance (fuel tank full position)
All gauges on the market are compatible, with a very few exceptions.
To connect the gauge, refer to the electrical diagram.
5.3. Water separating fuel filter (if the boat is factory rigged):
To protect the engine, a water separating fuel filter is fitted to the engine fuel supply line.
Number
DESCRIPTION
1
Water separating fuel filter
Interchangeable filter cartridge
2
Every time you use the engine, check that there is no water in the metal bowl:
-
Slightly unscrew the filler cap (do not remove it completely),
-
Drain the water,
-
Screw the cap back down if there is only fuel in the bowl.
Repeat the operation more often if your engine does not run properly.
INSTALLATION AND CIRCUIT: FUEL
CAUTION!
FITTING A FUEL GAUGE IS MANDATORY. IT IS SUPPLIED WITH THE
ENGINE. IF IT IS NOT PROVIDED, CONTACT YOUR DEALER.
240 Ohm
2
1
Page 24 / 50
Edition 2
Publicidad
