Descargar Imprimir esta página

Makita VC007GL Manual De Instrucciones página 13

Ocultar thumbs Ver también para VC007GL:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 87
2.
Before use, operators shall be provided with
information, instruction and training for the
use of the machine and the substances for
which it is to be used, including the safe
method of removal and disposal of the mate-
rial collected.
If foam/li uid comes out, s itch o
3 .
immediately.
4 .
Clean the water level limiting device regularly
and examine it for signs of damage.
5.
Al ays make sure that lters are correctly
installed before use. Do not use the cleaner
ithout lters in place. Replace a damaged
lter immediately. It is recommended to have
some spares as lters are consumable items.
AVOID UNINTENTIONAL STARTING. Be sure
6 .
switch is OFF when installing battery(ies).
7.
Do not attempt to pick up ammable materi-
als, re orks, lighted cigarettes, hot ashes,
hot metal chips, and sharp materials such as
razors, needles, broken glass or the like.
8.
NEVER USE THE CLEANER IN THE VICINITY
OF GASOLINE, GAS, PAINT, ADHESIVES OR
OTHER HIGHLY E X PLOSIVE SUBSTANCES.
The switch emits sparks when turned ON and
OFF. And so does the motor commutator during
operation. A dangerous explosion may result.
9.
Never vacuum up toxic, carcinogenic, com-
bustible or other hazardous materials such
as asbestos, arsenic, barium, beryllium,
lead, pesticides, or other health endangering
materials.
10. Al ays place the cleaner on a horizontal at
surface to prevent it from falling or moving
unintentionally.
11.
Never use the cleaner outdoors in the rain.
12. For Finland, this machine is not to be used
outdoors at low temperature.
1 3 . Do not use close to heat sources (stoves, etc.).
1 4 . If the exhaust air is returned to the room, it
is necessary to provide for an adequate air
change rate in the room. Reference to National
regulations is necessary.
15. Do not block suction inlet/outlet/cooling vents.
These vents permit cooling of the motor.
Blockage should be carefully avoided other-
wise the motor will burn out due to a lack of
ventilation.
1 6 . Keep proper footing and balance at all times.
17. Do not fold, tug or step on the hose.
18. Stop the cleaner immediately if you notice
poor performance or anything abnormal
during operation.
19. REMOVE THE BATTERY(IES). W hen not in
use, before servicing, and when changing
accessories.
20. Clean and service the cleaner immediately
after each use to keep it in tiptop operating
condition.
21. MAINTAIN THE CLEANER W ITH CARE. Keep
the cleaner clean for better and safer per-
formance. Follow instructions for changing
accessories. Keep handles dry, clean, and free
from oil and grease.
22. CHECK DAMAGED PARTS. Before further use
of the cleaner, a guard or other part that is
damaged should be carefully checked to deter-
mine that it will operate properly and perform
its intended function. Check for alignment of
moving parts, binding of moving parts, break-
age of parts, mounting, and any other condi-
tions that may a ect its operation. A guard or
other part that is damaged should be properly
repaired or replaced by an authorized service
center unless otherwise indicated elsewhere
in this instruction manual. Have defective
switches replaced by authorized service cen-
ter. Don ' t use the cleaner if switch does not
turn it on and o .
2 3 . For user servicing, the machine shall be dis-
mantled, cleaned and serviced, as far as is
reasonably practicable, without causing risk to
the maintenance sta and others.
2 4 . The machine should be technically inspected
by the manufacturer, or an instructed person,
at least annually, consisting of, for example,
inspection of lters for damage, air tightness
of the machine and proper function of the
control mechanism.
25. W hen carrying out service or repair opera-
tions, all contaminated items which cannot be
satisfactorily cleaned are to be disposed of ;
such items shall be disposed of in impervious
bags in accordance with any current regula-
tion for the disposal of such waste.
2 6 . REPLACEMENT PARTS. W hen servicing, use
only identical replacement parts.
W hen not in use, always store the cleaner
27.
indoors.
28. Wet lters and the interior part of the li uid
container shall be dried before storage.
29. Be kind to your cleaner. Rough handling can cause
breakage of even the most sturdily built cleaner.
3 0. Do not attempt to clean the exterior or interior
with benzine, thinner or cleaning chemicals.
Cracks and discoloration may be caused.
3 1. Do not use cleaner in an enclosed space where
ammable, explosive or toxic vapors are given
o by oil-based paint, paint-thinner, gasoline,
some mothproo ng substances, etc., or in
areas here ammable dust is present.
3 2. Do not operate the cleaner or any tool while
under the in uence of drugs or alcohol.
3 3 . As a basic rule of safety, use safety goggles or
safety glasses with side shields.
3 4 . Use a dust mask in dusty work conditions.
3 5. This machine is not intended for use by per-
sons including children with reduced physical,
sensory or mental capabilities, or lack of expe-
rience and knowledge.
3 6 . Children should be supervised to ensure that
they do not play with the cleaner.
3 7. Never handle battery(ies) and cleaner with wet
hands.
3 8. Use extreme caution when cleaning on stairs.
3 9. Do not use the cleaner as a stool or work
bench. The machine may fall down and may
result in personal injury.
12 ENGLISH

Publicidad

loading