Makita XCU08 Manual De Instrucciones página 8

Symbols
The followings show the symbols used for tool.
volts
direct current
meter per second
feet per minute
parts number of applicable saw
chain and guide bar
Wear a helmet, goggles and ear
protection.
Use appropriate protection for
foot-leg and hand-arm.
Do not expose to moisture.
Always use two hands when
operating the chain saw.
Beware of chain saw kickback
and avoid contact with bar tip.
Important safety instructions for
battery cartridge
Before using battery cartridge, read all
1.
instructions and cautionary markings
on (1) battery charger, (2) battery, and (3)
product using battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively
shorter, stop operating immediately. It
may result in a risk of overheating, possi-
ble burns and even an explosion.
4. If electrolyte gets into your eyes, rinse them out
with clear water and seek medical attention right
away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any
conductive material.
(2) Avoid storing battery cartridge in a
container with other metal objects
such as nails, coins, etc.
(3) Do not expose battery cartridge to
water or rain.
A battery short can cause a large current
flow, overheating, possible burns and
even a breakdown.
6. Do not store the tool and battery car-
tridge in locations where the tempera-
ture may reach or exceed 50 °C (122 °F).
7. Do not incinerate the battery cartridge
even if it is severely damaged or is com-
pletely worn out. The battery cartridge
can explode in a fire.
8. Be careful not to drop or strike battery.
Do not use a damaged battery.
9.
10. The contained lithium-ion batteries
are subject to the Dangerous Goods
Legislation requirements.
For commercial transports e.g. by third
parties, forwarding agents, special require-
ment on packaging and labeling must be
observed.
For preparation of the item being shipped,
consulting an expert for hazardous material
is required. Please also observe possibly
more detailed national regulations.
Tape or mask off open contacts and pack up
the battery in such a manner that it cannot
move around in the packaging.
11. When disposing the battery cartridge,
remove it from the tool and dispose of it
in a safe place. Follow your local regula-
tions relating to disposal of battery.
12. Use the batteries only with the products
specified by Makita. Installing the batteries
to non-compliant products may result in a
fire, excessive heat, explosion, or leak of
electrolyte.
13. If the tool is not used for a long period of
time, the battery must be removed from
the tool.
SAVE THESE INSTRUCTIONS.
CAUTION: Only use genuine Makita bat-
teries. Use of non-genuine Makita batteries,
or batteries that have been altered, may result
in the battery bursting causing fires, personal
injury and damage. It will also void the Makita
warranty for the Makita tool and charger.
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before
completely discharged. Always stop tool
operation and charge the battery car-
tridge when you notice less tool power.
Never recharge a fully charged battery
2.
cartridge. Overcharging shortens the
battery service life.
3. Charge the battery cartridge with room
temperature at 10 °C - 40 °C (50 °F - 104
°F). Let a hot battery cartridge cool down
before charging it.
4. Charge the battery cartridge if you do
not use it for a long period (more than
six months).
8 ENGLISH