Descargar Imprimir esta página

HOLZMANN MASCHINEN STM26 Instrucciones De Servicio página 34

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
Only operate the machine when it is in a perfect condition. Before each operation, a visual
inspection of the machine must be carried out. Safety devices and operating elements must be
checked carefully. Check screw connections for damage and tight fit.
15.1
Operating instructions
Before starting to work
Lubricate all lubrication points
Remove unused tools / parts
Make sure that the workpiece is properly
clamped.
Make sure that there are no chips on the
sliding surfaces.
15.2
Switch the machine on and off
15.3
Clamping a mortise drill
HOLZMANN Maschinen GmbH
ON-OFF switch
Press the green button (I) to switch on.
Press the red button (0) to switch off.
Loosen the screw of the drill chuck cover
Open the drill chuck cover
Release the lock screw (3)
Insert the mortise chisel (4) into the bushing (5)
Tighten the lock screw
NOTE:
front or to the back. This will allow the ejection of chips
when making mortises.
Insert the drill (2) upwards through the mortise chisel
Lock the drill in the drill chuck with the drill chuck key
www.holzmann-maschinen.at
After work have finished
Disconnect the machine from the power
supply.
Remove tools from the machine
Clean and lubricate the machine.
Cover the bare surfaces on the machien with a
corrosion protection agent to avoid corrosion.
Turn the slot to the left or right side, never to the
into the drill chuck (1)
(6)
OPERATION
34
STM26 | STM26S

Publicidad

loading

Este manual también es adecuado para:

Stm26s