HOLZMANN MASCHINEN STM26 Instrucciones De Servicio página 36

Cross travel
Mortising-Drilling
Worktable tilt (STM26S)
Column swivel (STM26S)
HOLZMANN Maschinen GmbH
Loosen the locking lever (1)
Move the work table in the desired direction with the
Retighten the locking lever (1)
Set the drilling deptht with the stops (1)
Feed the mortise drill steadily into the workpiece by
NOTE:
lever to the right (3), guide it upwards, let it engage again
and then pull it down again.
NOTE:
in several steps (one step approx. 2 cm).
NOTE:
direction of movement of the workpiece, this enables the
ejection of the chips when making mortises.
Loosen the locking (1)
Set the desired worktable tilt with handwheel (2) (read off
Retighten the locking
Loosen the locking (1)
Set the desired column with handwheel (2) (read off the
Retighten the locking
www.holzmann-maschinen.at
handwheel cross travel (2)
pulling down (4) the operating lever (2)
If there is not enough travel, press the operating
When making deep mortises, carry out the process
Make sure that the ejection slot (1) is always in the
the angle on the scale (3)).
angle on the scale (3)).
OPERATION
36
STM26 | STM26S