Toro Recycler 22280 Manual Del Operador página 18

Operating the Self-Propel
Drive and Engaging the
Blades
This machine has 3 ground speeds: 1 (slow), 2
(medium), and 3 (fast); it also has a Neutral (N)
position. The self-propel-drive lever is located below
and behind the fuel tank
Figure 16
1. Self-propel-drive lever
To engage the blades, do the following:
1. Push and hold the blade-control lock lever
forward to release the blade-control bail (A of
Figure 18).
2. Pull the blade-control bail to the handle and
release the blade-control-lock lever; the blade
should engage (A of
(Figure 16).
Figure 18).
1. Move the self-propel-drive lever to the desired
ground speed.
2. Start the engine.
3. To operate the self-propel drive, squeeze the
self-propel-drive bar
Note:
You can vary the ground speed by
increasing or decreasing the distance between
the self-propel-drive bar and the handle.
g024167
3. Release the blade-control bail to disengage the
blade (B of
lever resets to lock the blade-control bail.
Figure 18
17
(Figure 17).
Figure 17
Figure 18). The blade-control-lock
g331713
g237185