Toro Recycler 22280 Manual Del Operador página 30

7. Mark the brake cable
the jacket until there is approximately 8 mm
(5/16 inch) of slack
Figure 35
1. Mark the cable here
Figure 36
1. Slack— 8 mm (5/16 inch)
8. Torque the cable-clamp screw to 11 to 14 N∙m
(99 to 121 in-lb) to lock the adjustment in place.
9. Install the belt cover with the bolts that you
removed to take off the 2 belt covers.
10. Connect the wire to the spark plug.
(Figure 35), then adjust
(Figure 36).
Cleaning under the Belt
Cover
Service Interval: Every 50 hours—Remove grass
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug.
3. Remove the belt cover
mower housing.
g239133
1. Belt cover
4. Lift off the cover and brush out all the debris
around the belt area.
g239134
5. Install the belt cover.
6. Connect the wire to the spark plug.
29
clippings and debris from under the
belt cover.
(Figure 37) from the
Figure 37
g024255