Publicidad
Idiomas disponibles
Idiomas disponibles
100 V - 230 V
(50Hz - 60Hz)
POWER SUPPLY
PROGRAMMING
BUTTONS
TACT
LED
(MASTER MOTOR)
RECEIVER JUMPER
CLOSED = ENABLES RF
OPEN = DISABLES RF
ANALOG LIMIT SWITCH
REED (SLAVE MOTOR)
2.4 – CONNECTING THE "ENC1" AND "ENC2" ENCODERS
It is used to connect the encoder, by using a proper cable, between the motor
and the control unit. Inside the operator gearbox there are sensors that pro-
vide the unit control with information about the movement direction and the
position of the gate during the operation. Such information is essential for the
automator's proper operation.
18
SYSTEM
GROUNDING
ANALOG LIMIT
SWITCH REED
Figure 1
INDUCTION MOTOR
INDUCTION MOTOR
OPTIONAL
'ALCANCE'
RECEIVER
ENCODER CABLE (MOTOR 2)
ENCODER CABLE (MOTOR 1)
(SLAVE)
M
(MASTER)
M
(OPTIONAL) LOCK
PROG
(OPTIONAL)
COURTESY LIGHT
Publicidad
