Publicidad
Idiomas disponibles
Idiomas disponibles
purge the unit of trapped air. Vent hole should be checked periodically for clogging. The vent hole on a High Head
application may cause too much turbulence. If you choose not to drill a vent hole, be sure the pump case and impeller
is covered with liquid before connecting the pipe to the check valve. NOTE: THE HOLE MUST BE BELOW THE
BASIN COVER AND CLEANED PERIODICALLY. Water stream will be visible when pump is operating.
4. Pump should be checked frequently for debris and/or build up which may interfere with the float "on" or "off"
position. Repair and service should be performed by an Authorized Service and Warranty Center.
5. Maximum operating temperature for standard model pumps must not exceed 130°F (54°C).
6. Do not operate a pump in an application where the Total Dynamic Head is less than the minimum Total Dynamic
Head listed on the Pump Performance Curves.
7. For health reasons, do not unplug, turn off, or disable pump and use pump tank system as a way to fill up a sink or
laundry tray, etc.
8. Pumps must be installed in accordance with the National Electrical Code and all applicable local codes and
ordinances. Pumps are not to be installed in locations classified as hazardous in accordance with National Electric
Code, ANSI, NFPA 70.
Pre-Installation
SPECIFICATIONS
SWW05007K
Power supply
Liquid temp. range
Discharge size
SWW10007K
Power supply
Liquid temp. range
Discharge size
SWF05004K
Power supply
Liquid temp. range
Discharge size
SWF10004K
Power supply
Liquid temp. range
Discharge size
Installation
CAUTION: Always use the handle to lift the pump. Never use the power cord to lift the pump. To avoid skin burns,
unplug the pump and allow time for it to cool after periods of extended use.
Recommended Installation For All Applications
For Professional Technical Support call 1-844-242-2475
115V, 60 HZ., 20 Amp Circuit
32°F to 130°F
2 in. FNPT
230V, 60 HZ., 20 Amp Circuit
32°F to 130°F
2 in. FNPT
115V, 60 HZ., 20 Amp Circuit
32°F to 130°F
1-1/2 in. FNPT (include 2"
flange)
230V, 60 HZ., 20 Amp Circuit
32°F to 130°F
1-1/2 in. FNPT (include 2"
flange)
3
Publicidad
