Publicidad
Idiomas disponibles
Idiomas disponibles
A float switch is included and factory-wired in the pump circuit to provide automatic operation once the float switch
is secured properly to the outlet pipe. Use the diagram above to secure the float switch properly and obtain the
proper tether to customize the on-off cycle to each application.
Note: Failure to keep within proper tether limits may prevent reliable switch operation.
Note: Cable must be mounted in horizontal position.
Care
CAUTION: Always use the handle to lift the pump. Never use the power cord to lift the pump. To avoid skin burns,
unplug the pump and allow time for it to cool after periods of extended use.
Do
1. Read all installation material with the unit.
2. Inspect unit for any visible damage caused by
shipping. Contact dealer if unit appears to be
damaged.
3. Remove all debris from the basin. Be sure that the
pump will have a hard, level surface beneath it.
4. Be sure that the area is large enough to allow proper
clearance for the level control switch(es) to operate
properly.
5. Always Disconnect Pump From Power Source
Before Handling.
Always connect to a separately protected and properly
grounded circuit.
6. Install a check valve and a union in the discharge
line.
7. Review all applicable governing codes and verify
that the installation conforms to each of them.
8. Test pump immediately after installation to be sure
the system is working properly.
9. Consider a two-pump system with an alarm where
an installation may become overloaded or primary
pump failure would result in property damages.
10. Consider a D.C. Backup System where a sump or
dewatering pump is necessary for the prevention of
property damages from flooding due to A.C. power
disruptions, mechanical or electrical problems or
system overloading.
11. Inspect and test system for proper operations at
least every 3 months.
For Professional Technical Support call 1-844-242-2475
Do Not
1. DO NOT install on sand, gravel or dirt.
2. DO NOT ever cut, splice, or damage power
cord (Only splice in a watertight junction box).
3. DO NOT carry or lift pump by its power cord.
4. DO NOT use an extension cord.
5. DO NOT use a discharge pipe smaller than the
pump discharge.
6. DO NOT utilize this unit for pumping gasoline
or other hazardous liquids.
5
Publicidad
